-+ 0.00%
-+ 0.00%
-+ 0.00%
Shimizu 3D-Prints 1-Meter-Class Rocket Propellant Tank
Share
Listen to the news
Shimizu 3D-Prints 1-Meter-Class Rocket Propellant Tank
  • Shimizu announced on November 18, 2026, that it fabricated a one-piece, 1-meter-class rocket propellant tank using metal 3D printing.
  • Internal pressure testing confirmed a burst pressure of up to 1.7 MPa for the tank, among Japan's largest produced using metal 3D printing.
  • The robotic manufacturing system emerged from joint research with the Japan Aerospace Exploration Agency begun in 2022, combining metal deposition with corrective machining.
  • Research on large liquid propellant tanks has continued since 2024 under Japan's Space Strategy Fund.
  • The company targets integrated fabrication of 2.5-meter-class tanks for small and medium-lift launch vehicles by fiscal 2028.


Disclaimer: This news brief was created by Public Technologies (PUBT) using generative artificial intelligence. While PUBT strives to provide accurate and timely information, this AI-generated content is for informational purposes only and should not be interpreted as financial, investment, or legal advice. Shimizu Corporation published the original content used to generate this news brief on November 18, 2026, and is solely responsible for the information contained therein.

Disclaimer:This article represents the opinion of the author only. It does not represent the opinion of Webull, nor should it be viewed as an indication that Webull either agrees with or confirms the truthfulness or accuracy of the information. It should not be considered as investment advice from Webull or anyone else, nor should it be used as the basis of any investment decision.
What's Trending